Outer Limits 4x4 Board

I'm after any rear maxi stuff anyone has laying around as mine is broken



Let me know what you got

I only sold one a bit over a week ago

check my post i see you are online

pm sent re 24 spline maxi centre

Hobie18 wrote:pm sent re 24 spline maxi centre

Cheers matey, I'm procrastinating about it

how did you break that???

serg

I...................don't know

http://www.aulro.com/afvb/technical-cha ... d-see.html

Well that farks that, I can;t use a later centre as the locking dogs are different sizes, early are 50mm the later are 45mm

Spoke with Barry just a moment ago, great to speak to

So looks like I'm back to square 1

cloughy wrote:Well that farks that, I can;t use a later centre as the locking dogs are different sizes, early are 50mm the later are 45mm

Spoke with Barry just a moment ago, great to speak to

So looks like I'm back to square 1

Would have only been about $250 to convert that ARB you just sold to 24-spline...

ISUZUROVER wrote:

cloughy wrote:Well that farks that, I can;t use a later centre as the locking dogs are different sizes, early are 50mm the later are 45mm

Spoke with Barry just a moment ago, great to speak to

So looks like I'm back to square 1

Would have only been about $250 to convert that ARB you just sold to 24-spline...

Still would have needed axles, or get jeff to broach to 28 spline oh and $300

Think it'll end up getting an end cap machined up to suit

so it was a 28spline locker?

i wonder how many k's that has done.

Serg

uninformed wrote:so it was a 28spline locker?

i wonder how many k's that has done.

Serg

1984, by the looks of the part no, real early unit when they use to fly cut the one of the carrier bearing retainers oversize

I extracted it from an early 2 door I wrecked about 6ish years ago, it had Kaymar rear bar, front bar, 305 chev, recaro's and appeared to have been loved in its early days, but was very rough from sitting a long while

not bad for something thats 24 years old....

thanks for the info.

Serg

Got a 28 spline maxi v1 short and long axle + two end flanges floating around if that may help... (got no inner bits.)