Outer Limits 4x4 Board

does anybody know what the difference is between the two box and if a GQ can take a GU gearbox.

Thanks

im looking at putting a GU td42 into my GQ that is currently a 2.8td. Was wondering if anybody knew if the GUs box is going to fit in with out to much drama.
Thanks

You may have some problems with the gear stick shape

As ive read somewhere that they are different to clear the GU dash.



But I can tell you a GQ td42 box will fitt

and the 2.8 transfer case will bolt up to the 4.2 gear box if you swap the inside gear casing or grind off the oil lip from the 2.8 transfer.

This will allow you to use the smaller tail shafts from the 2.8

And the 2.8 x member will also bolt straight up to the td42 box

I put a gq 4.2 box in my gu and i had to cut the floor up because the gear stick was to far forward so i imagine that you might have the opposite problem. do you have a body lift because that would help

Dane, not sure on fitting the GU box into the GQ, i have this feeling that the shifter will be placed about 50-70mm closer to the centre console, and you might have to hack up the floor,

also, to swap the 2.8 transfer case and the 4.,2 transfer case, just swap the 2 front seal housings and they will match up no probs, we have done this on the old mans truck no probs,

does any one know how if or how hard the gearshift is to bend.

Oxy and some stillsons oughta do it