Outer Limits 4x4 Board

As above.

I am looking for regular steel tube with the above OD to build my buggy with.

so far my options are 4130 @

1.5"

PS3821 @ A$20.30/m

PS3824 @ A$19.58/m

PS3828 @ A$25.57/m

PS3830 @ A$27.49/m


1.75"

Ps4414 @ A$24.08/m

PS4416 @ A$23.34/m

PS4421 @ A$20.37/m

PS4424 @ A$28.46/m

PS4430 @ A$31.66/m


I don't mind paying for the steel but I will need larger radius dies to bend the thin stuff to justify its use so it will end up adding a grand or two to the project.

OPW sell 650mpa steel which sounds good and is my preferred option if i cannot get steel in QLD.

So what is everyone using? Might send the 44mm die back and get a 48mm.

cheers bru

Ring performance metals in windsor.

Dont have the number handy but they should be able to look after you.

Nick

Extreme Motorsports
197 Toombul Road
Northgate
Queensland
Australia 4013
Phone: 07 3630 4377
Fax: 07 3630 4355

These guys are onsellers for Performance Metals.
They can get what you want either delivering or pick up.

Thanks fellas,

The prices above are from performance metals. I will get their DOM price and see how it compares. I was hoping for a local supplier.

I looked up Atlas, metalcorp, smorgon / one steel etc

Might have to just bite the bullet.

I need to do a cage for my brother and the buggy so about 60m to start off. Need to take out a second morgage

performance metals are great to deal with, ive bought all the tube for my truck through them and had no drammers

rob

yeah they are good I have delt with them in the past, but i bought 1 length of 44, 3 lengths of 38 and a bit of 3mm plate 3 ft x 1.5ft - total cost $1100. it was 4130.

thanks again