Page 1 of 1

GAS TANK WONT FILL!

Posted: Tue Aug 12, 2008 6:26 pm
by KYSI
Hey guys just had my tank tested at a gas joint...passed with flying colours, but now i have tried to fill it and the most i can get in is 8 cents!! the gas tank is empty and i need to put gas in it before mounting back on the patrol because its strait gas...i rang the gas place and i had it upside down tryng to fill it so the floats would of been all over the place but turned it up the right way and still nothing......anyone got any ideas?

Posted: Tue Aug 12, 2008 6:32 pm
by zagan
might have had an air lock at the fill handle/cap.

though wouldn't simply be a case of the tank being full of air and can't release/remove the air to fill up with gas?

can't help too much though use LPG forklifts and the air lock can happen and not allow gas to get into the engine.

Posted: Tue Aug 12, 2008 6:57 pm
by pcman
some tanks have a shutoff valve on the inlet

gas

Posted: Tue Aug 12, 2008 6:58 pm
by KYSI
i have had the filler nozzle off and drained it, its complety empty of presure so im taking it back tomorow to the place that done it and get them to look at it hopefully its just a simple problem

Posted: Tue Aug 12, 2008 7:02 pm
by CazzaW
i had the same problem with my gas tank after i had it tested. could only get 15cents or so in.
turned out to be a sticky one way valve or something. it cost about $150 to get replaced. i wasn't happy cause i couldn't understand how it passed a test, but the bloke said "WE TEST FOR LEAKS NOT IF YOU CAN FILL IT".
bit of bull shit if you ask me.

gas

Posted: Tue Aug 12, 2008 7:10 pm
by KYSI
i had filled the gas tank prior to the test so it was working before it went in there, so hopefully its there fault. lol didnt know i was gonna test it until i decided i would and lost 3/4 tank of gas

Posted: Tue Aug 12, 2008 7:39 pm
by zagan
What we do is push in the centre of the valve it's a pin that moves in and out, move it a few times and seems to go ok after that on the forklifts.

may help someone, if it's the same deal.

gas

Posted: Tue Aug 12, 2008 7:55 pm
by KYSI
i put a stick in the valve bit where u fill up and haha burnt the sh!t out of my hand wont be doing that again, so its like the hose has filled up but nothing is getting in the tank....really have no idea best to let apa fiddle with it

Posted: Tue Aug 12, 2008 8:47 pm
by VXPSI
lol hope ur hands hurts

Re: GAS TANK WONT FILL!

Posted: Wed Aug 13, 2008 6:45 am
by V8Patrol
KYSI wrote:Hey guys just had my tank tested at a gas joint.....



....anyone got any ideas?
TAKE IT BACK :!:

If its been 'properly tested', they will have replaced a couple of valves ( this should be done regardless of working condition).

Sounds like an issue with the AFL valve, its the one thats designed to shut off the gas flow when the tank is 80% full, yours has shut off even tho the tank is empty....

again.....

TAKE IT BACK :!:

Kingy

Posted: Wed Aug 13, 2008 8:18 am
by bogged
was the servo out of gas?

gas

Posted: Wed Aug 13, 2008 1:11 pm
by KYSI
tried 3 different servos lol....took it back today filled fine, i think the 1 way valve was stuck and when i pushed the stick into it freed it up because in the morning it was really free so took it back to APA today and they filled it no dramas...even replaced a bit of gas that i lost when i took it there 3/4 full :) so now i can go about finnishing my truck for the engine work to start :twisted:

thanks for all your help guys muchly appriecated

cheers kyal