Outer Limits 4x4 Board

I searched, I really did, but I couldn't find any thoughts on that 3M grip tape that many people use atop their sliders instead of chequerplate...?

Where can I get it, is there a better alternative, and price when *you* bought it last?

Thanks,

if your talking about the grip stuff you just stick on, you can get it from hardware stores, bought some for my skateboard...but thats goin back 2-3 years, wasnt expensive.

i just bought a roll of the 3M stair tape about 50mm wide and it lasts ages. lots of rock rash and its still there. From bunnings its about $35 bucks for the roll

You can also get it at a sports store.

you can also get it from boat supply stores, who always seem to have it in a lot more width sizes for different application. It's used alot as non slip boat deck grip.

Would have to be one of the best mods I've done in the past. Sliders, rear bar and also a bit on the top surfaces of the main bar section of the bullbar (the flat areas just below the headlights if you know what I mean).

Any where you might need to climb off when you are up to your freckle in a bog hole trying to get to the snatch strap you attached earlier just in case.......you're nodding aren't you....you've been there before.

Simple and cheap!

Or any safety shop like RSA, Gas and Gear etc.

Bunnings sells it.

sweet, thanks fellahs.

i got mine from supercrap and its been on for over two years and still good. its about 500mm wide.

robsrunner2 wrote:i got mine from supercrap and its been on for over two years and still good. its about 500mm wide.

you must have HUGE sliders

oops, 50mm wide

benhl wrote:

robsrunner2 wrote:i got mine from supercrap and its been on for over two years and still good. its about 500mm wide.

you must have HUGE sliders

Nah they are outriggers!

yhe supercheap have the 3m stuff, get a few metres long by 50mm wide.

dean,

Mine have spot welds work a treat too.

A few years back I bought a sheet designed for a skateboard deck - $10 from a surf shop, from memory.

I used a bit to wrap a handgun frame, to provide better grip. When the government bought the gun back (5 years ago now ) they added $90 to the price for the "aftermarket grip."