Page 1 of 1
ANY front locker for 3L V6 Pajero??
Posted: Sat Sep 06, 2008 12:44 pm
by muffins
I've got a 94 Pajero 3L V6 auto. Of course my model is the only one with no front air locker available! So are there ANY alternative diff locks available at all???
Otherwise i thought i read somewhere that the air locker for the slightly larger 8" diff (RD110) can be made to fit?
Re: ANY front locker for 3L V6 Pajero??
Posted: Sat Sep 06, 2008 2:08 pm
by -Scott-
muffins wrote:I've got a 94 Pajero 3L V6 auto. Of course my model is the only one with no front air locker available! So are there ANY alternative diff locks available at all???
Otherwise i thought i read somewhere that the air locker for the slightly larger 8" diff (RD110) can be made to fit?
Your Paj has a 7.5" front diff, for which no locker is available. The 8" diff from the manual will fit, and is a relatively simple swap, although you'll need a few other bits from the donor vehicle too. It's been discussed here relatively recently - try trolling through the first few pages of the forum.
Edit: From the FAQ:
Front arb locker installed. 8inch genII housing swaps in!!
Front Locker for NJ Auto (Now in FAQ...
)
Good luck,
Scott
Posted: Sat Sep 06, 2008 3:45 pm
by CapnCrunch
I've got an ARB RD110 in the front of my Gen I. It originally had the smaller diff but I swapped in a Gen I V6 8" diff, along with the mounts and CV axles. I'm not sure about the Gen II, but on mine I had to have the front drive shaft shortened by about 1.5" at a driveline shop. Other than that, the rest was pretty much a bolt-in.