I have gone down the path of the weber dgav 32/36 install on a stock 1.3L sierra (96). This was done cause the old carby needed a rebuild and thought it was a good time for an upgrade.
I have installed the adaptor plate, carby, air filter, hoses etc. and when the engine was started it idled very roughly (ie cycling between 1800 and 200 RPM every few seconds). I am thinking this could be a vacuum leak, but dont know how to track this down. any suggestions for finding a vacuum leak or where to start looking?
Also wondering what people have done with the EGR valve? at the moment i have the egr valve plugged, the two vacuum hoses connected to the temp switch at the thermostat housing are plugged, and the two vacuum ports in the intake manifold just next to the little solenoid vacuum switching (green plug) thing are also plugged (just forward of center on the manifold). Is this setup ok? And if the EGR valve is to connected properly how should this be done?
Thanks heaps!
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
weber carby install
Weber conversion
To check for a vacuum leak spray aerostart around the manafold and base of the carby, if it is leaking it will get sucked in and you will hear change in the motor.
Did you get the carby from GEM off ebay, I got mine off him and it was way too lean. He was a dick and wouldnt sell me the jets to fix it because he wouldnt admit it could be wrong. Repco can get you jets from redline. get the weber sierra manual, I think there i one at suzukiinfo, it tells ou how to rejet it and the recomended jets.
When you get that right you should put extractors on, they let my 1.3 rev out heaps smoother.
Did you get the carby from GEM off ebay, I got mine off him and it was way too lean. He was a dick and wouldnt sell me the jets to fix it because he wouldnt admit it could be wrong. Repco can get you jets from redline. get the weber sierra manual, I think there i one at suzukiinfo, it tells ou how to rejet it and the recomended jets.
When you get that right you should put extractors on, they let my 1.3 rev out heaps smoother.
just dont blow yourself up
I saw a mechanic mate of mine nearly remove his hair about two weeks ago whe he sprayed carby cleaner (also works well) on a falcon motor that also had a shorting spark lead that wasn't all that obvious at the time.
Farkin funny and farking big fire ball scared the shit out of mate though
keep it away from leads
cheers andrew
I saw a mechanic mate of mine nearly remove his hair about two weeks ago whe he sprayed carby cleaner (also works well) on a falcon motor that also had a shorting spark lead that wasn't all that obvious at the time.
Farkin funny and farking big fire ball scared the shit out of mate though
keep it away from leads
cheers andrew
85 high roof 1.3, 6.5 tc, air lockers,ruf and 34 swampers. yep its an ugly pos.
Who is online
Users browsing this forum: No registered users and 0 guests