Outer Limits 4x4 Board

Have looked everywhere and cannot find ecu pinout diagram for this ecu.

stripped the loom ages ago and about to install and forgot what some of the wires are. (im sure i had the diagram when i did this)

did searches here and looked on suzukiinfo and googled for the past hour but came to a blank .

Go to suzukiinfo and look at the Suzuki G13BA TBI Wiring diagram.

Should be what your after.

Thanks but no thats not what im after.

im after the view of the sockets and their purpose eg a1 a2 a3... , wires colours and purpose.

Try this , not sure if its the one you want thou

http://www.yankeetoys.org/mini4x/efiswap/efiswap.htm

Chris

no i got that one , it was the same plug config but the wires were all different colour to what i have .

either of these help

The pin-out for the single point injection is pretty much the same between trackers, vitara's, metro's etc etc. The wire colour and trace colour do differ, but the acutal pin-out matches. When i swapped MUD4B's old setup onto Pyro's zook i used a Geo tracker diagram to check and trace the loom.

Layto....

Cheers , ill figure it out. gonna have a pretty shit hot sierra soon when i finish buying all the bits and pieces.