Page 1 of 1

Bit of metal in diff

Posted: Thu Sep 25, 2008 8:59 am
by markc_GQ
Drained my 88 GQ's front diff last night, and found this stuck to the magnet on the bottom plug:

ImageImage

Anyone know what it is? (the metal, not my fingers :finger:

I'm not hugely worried, just thought I'd check in case I should be :?

Mark

Posted: Thu Sep 25, 2008 9:31 am
by jessie928
have you got or had an air locker installed?

Posted: Thu Sep 25, 2008 9:47 am
by markc_GQ
jessie928 wrote:have you got or had an air locker installed?
Nope. Wish I did tho :)

Posted: Fri Sep 26, 2008 5:42 pm
by MICK77
I have no idea what that is. Was the oil discoloured or have metallic particles in it? If so it may warrant pulling the centre out & having a look.

Posted: Fri Sep 26, 2008 7:50 pm
by Wrench_Pilot_86
i've drained worse outta 20,000km old Landcruisers and Prados at work, i wouldn't bother about it unless the diff is whiny or making banging noises around corners, it looks like a shaving off the crown wheel or pinion, get worried when chunks of gear teeth come out with the oil

Posted: Fri Sep 26, 2008 10:13 pm
by Fmx_Aus
Mate, dropped the oil out of the rear (LSD) in my gq tonight and found the exact same thing, along with another little peice. 240,000k's on it, oil was shithouse (only just bought the vehicle). Still drives alright so I'm happy.

Posted: Sat Sep 27, 2008 12:48 am
by jessie928
Fmx_Aus wrote:Mate, dropped the oil out of the rear (LSD) in my gq tonight and found the exact same thing, along with another little peice. 240,000k's on it, oil was shithouse (only just bought the vehicle). Still drives alright so I'm happy.
GQ lsd's ( or any LSD or that matter) woudl get dirty oil because of the slipping wearing clutches.

JEs

Posted: Sat Sep 27, 2008 8:42 pm
by Tomo_89
I wouldn't be worried.. I've seen worse. i once saw a chunk of metal the size of your thumb come out of a truck diff.. owner said it was making a slight knocking noise

Posted: Tue Sep 30, 2008 8:41 am
by markc_GQ
Thanks for the advice guys. The oil was in great condition, and there wasn't really anything else in there to indicate issues.

Regarding diff noise, the whole fourby has been sitting on jack stands for a couple of years, so I'll have to wait till I finish doing it up to see if there's any noise, but from memory it was ok.

Anyway, from the sounds of it it should be fine... which is good to hear :)


Mark