Outer Limits 4x4 Board

Does anyone know anywhere in Brisbane where I can get leaf springs hot reset? I have what I think is a good setup on our Zook but the rear springs are now starting to sag a little. Not real fussed on cold reset.
Thanks

Don't know about a hot reset, but I got a set reset by Bayside springs quite a while back. They heated (tempered) them AFTER resetting. They have held their shape well.

http://www.carrolls.com.au/ ....

There is a spring joint on Abbestford road under the ICB. I have no idea what they do or if they are any good, I just drive past them everyday.

I myself just cold set springs in my press, have done so for years. Some last at that height for years, others will sag again quickly.

I have to do my passengers side front on Saturday as I bent the bottom 2 leaves in the pack a few weeks ago and the whole pack has since sagged

Guts wrote:There is a spring joint on Abbestford road under the ICB. I have no idea what they do or if they are any good, I just drive past them everyday.

mayne spring works.. been there.. would probably recommend carrolls at wacol over mayne anyday..

i went to mayne spring works with some custom springs for my 40 and they weren't very keen to help out.. did what I asked though..

the guys at carrolls were a bit more receptive and have a bigger setup then mayne.. not sure if mayne would do the hot resetting..

i got quoted 75$/pack if i remove them from the vehicle but that was a normal reset not a hot one.. that said the height they did set has held for 2yrs now.. (or maybe it was my leaf spring selection?

Thanks guys, Looks like some phone calls coming up.