Outer Limits 4x4 Board

I had someone lined up to fit my new 4.16 gears but he is a bit reluctant to give it a go. Is anyone here keen to fit them for me? I'd have a go myself but I really have no idea what i'm doing.

meads02 wrote:I had someone lined up to fit my new 4.16 gears but he is a bit reluctant to give it a go. Is anyone here keen to fit them for me? I'd have a go myself but I really have no idea what i'm doing.

do you have a full bearing and seal kit? if so i will fit them. have you had the case apart yet? just sometimes you need the idler shaft and thrust washers also.

cheers mark

I bought a rebuild kit with the gears from locktup4x4. I haven't had the case apart yet. where can i get these parts? i might as well get them as well

the kit consists of 2 gaskets, 3 seals and 5 bearings

meads02 wrote:the kit consists of 2 gaskets, 3 seals and 5 bearings

too easy, that's the usual basic kit and most of the time really all you will need.. when did you want it done by?

cheers mark

oh sweet. i'd like it to be done asap but whatever suits you. thanks

PM sent

Seriously why rob yourself of money, I'd never done it before and it was easy with instructions

http://www.trail-gear.com/tech/zuk65gears/index.html

Buy a bearing puller from super cheapy and get some pipe off cuts from somewhere and roberts your fathers brother.

i'm not very competent when it comes to mechanical things. mud4b said he can do it and he's not that far from me so i'll see what happens

Got my gears, got my bearings, got my press, all I've got to get now is time.