NAVARA D21 DIFFS
Posted: Wed Oct 22, 2008 1:31 am
After reading the Forum Post on Nissan Diff specs, I was under the impression that my 96 Dual cab had an "HG43" diff combination, but I have now seen these parts and they look very different to mine.
I have checked the ratio (roughly) and it appears to be 4.8:1.
The Plate (the diff bit I think) nominates that it is CA48.
From my limited understanding, this would appear to tie in with the 4.8:1 ratio and would mean that the front diff would be an R180 front and C200 rear. (I also measured the outside of the rear cover and a 233mm crown wheel would definately not fit, but a 200mm crown wheel looks like it would fit.
Can anyone advise:
1) Are these assumptions correct; and
2) If that is the case could I put a different ratio from another nissan with the CA designation eg. CA41 - Found on 720's
Thanks in advance.
I have checked the ratio (roughly) and it appears to be 4.8:1.
The Plate (the diff bit I think) nominates that it is CA48.
From my limited understanding, this would appear to tie in with the 4.8:1 ratio and would mean that the front diff would be an R180 front and C200 rear. (I also measured the outside of the rear cover and a 233mm crown wheel would definately not fit, but a 200mm crown wheel looks like it would fit.
Can anyone advise:
1) Are these assumptions correct; and
2) If that is the case could I put a different ratio from another nissan with the CA designation eg. CA41 - Found on 720's
Thanks in advance.