uni joints????
Posted: Thu Oct 23, 2008 2:39 pm
does anyone know if sierra's have different sized uni joints in the drive shafts throughout production?
cheers.
cheers.
Page 1 of 1
Posted: Thu Oct 23, 2008 3:00 pm
i have seen external and internal clips used but same size uni for WT and NTs
Posted: Thu Oct 23, 2008 5:49 pm
bursons told me that there are three different sizes listed and i had to pull one out to match up.
but ive been too lazy to do it even though i know one front one is on its way out
could be bullshit though from some pimple faced 17 year old school dropout at bursons
but ive been too lazy to do it even though i know one front one is on its way out
could be bullshit though from some pimple faced 17 year old school dropout at bursons
Posted: Thu Oct 23, 2008 8:08 pm
i just swaped a 1ltr transfer end onto a 1.3 wt jack shaft. you just have to use the right caps as the wt has external clips and 1 ltr has internal clips.
both caps fit in both holes just can't put the clips on if its the wrong one.
both caps fit in both holes just can't put the clips on if its the wrong one.
Posted: Fri Oct 24, 2008 4:24 pm
ta thanks guys!!!!