Page 1 of 1
Fitting new turbo HELP.
Posted: Tue Nov 04, 2008 12:05 pm
by Fmx_Aus
Just put a new T70 on the car. All hooked up. Primed it.
But it keeps pissing oil out of where the feed line going into the top of the turbo. Got me stuffed what it is. Is there something inside the turbo that need to be opened??
Any help would be great.
Posted: Tue Nov 04, 2008 1:33 pm
by Fmx_Aus
Thanks for the move.
Seems the intake wheel isnt spinning, therefore not pushing the oil through the turbo
Posted: Tue Nov 04, 2008 3:50 pm
by cooter
there wasn't a plug jammed down the feedhole was there?
Posted: Wed Nov 05, 2008 9:43 am
by Fmx_Aus
Nah mate no plug in there.
Got me stuffed
Posted: Wed Nov 05, 2008 10:18 am
by bludger
got any pics
Posted: Wed Nov 05, 2008 3:18 pm
by NutterGQ
is it a "Monsta/Ebay Turbo"?
Posted: Wed Nov 05, 2008 4:11 pm
by MICK77
There should be a copper sealing washer on each side of the union the engine oil enters the turbo. If one is missing the union bolt may bottom out but the union will not seal against the turbo housing thus resulting in a oil leak.
As stated above pics would help a lot.
Micko
Posted: Wed Nov 05, 2008 7:44 pm
by Fmx_Aus
Yep after talking to a few people the copper washers might be the problem. I have both of them, but they are a little worn.
So will get some tomorrow and try them out.
Not sure on brand mate, come as a spare with the car a while back.
