Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

TD42 DTS Turbo Kit Boost

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 43
Joined: Sat May 28, 2005 3:33 pm
Location: Townsville QLD

TD42 DTS Turbo Kit Boost

Post by Dicko1980 »

Hi Guys

I've got a DTS kit fitted to my 94 TD42 Coil Cab that has just had a full engine and fuel pump rebuild 7000km ago and am wondering what sort of boost should I be looking to run when the car gets Dyno'ed in a couple of weeks. The only mods above the standard DTS kit which is fitted is a 3" dump and 3" Mandrel Bent Straight through exhaust. Any help would be appreciated.

Cheers
dicko1980
Dicko1980
Posts: 4275
Joined: Thu Dec 19, 2002 2:12 pm
Location: Sydney

Post by ozy1 »

i have the same kit, just on a 360k motor, i had mine put on at 310k's, at the moment i have a 2.5" exhaust, it was tuned with 11psi, i changed all ther intake pipework, and it seems to sit on 12 psi when the throttle is open, ill add a 3" exhaust later and get it retuned,
Posts: 350
Joined: Sun Mar 02, 2008 10:12 pm
Location: Mackay Qld

Post by Tomo_89 »

is it intercooled? anything over about 10 psi non intercooled the intake temps are gunna be up a bit high anyway.. It really depends how much power you want to make and where you want to make it. Sure you might make good power on the dyno running big boost but it will be like driving an N/A untill you get it reving. I would say run about 12 pound with a good intercooler and tune to suit.. if you want to go any higher than that then you will have to start looking at pump mods ect.. to keep the fuel up to it. Just make sure you keep an eye on the pyro temps. Also i believe some of the older td42's have lighter pistons and cant handle as much boost.
01 td42 GU patrol ute, with extra bits and pieces.
[quote="Bluefreak"][quote="ofr57"]flex is over rated :finger:[/quote]

You drive an IFS too, huh...???

:D[/quote]
Posts: 43
Joined: Sat May 28, 2005 3:33 pm
Location: Townsville QLD

Post by Dicko1980 »

The motor that's in my truck has the heavier pistons and rods.

Cheers
dicko
Dicko1980
Posts: 413
Joined: Sun Apr 27, 2008 8:41 am
Location: South Is, NZ

Post by twodiffs »

Pretty sure the heavier pistons were used in vehicles from 88-92?
and from 92 onwards on the turbo one's. Non turbo from 92 had the lighter pistons.
1991 GQ TD42 Safari, 5spd, 4" Lift, 35" shovels, Locked & Loaded.
Posts: 169
Joined: Thu May 15, 2008 3:42 pm
Location: Central Coast, NSW, Australia

Post by SLASH »

Hi Dicko,i had a dts kit fitted to my old 91 GQ with 160,000.Was fitted and tuned by Berrima diesel and ran 12psi,no I/C.Not sure what egt's were but it went really well,i loved it.Had no dramas at all.Had it for a few years and it got stolen with it and it was still going hard when it did.Cheers.
Posts: 169
Joined: Thu May 15, 2008 3:42 pm
Location: Central Coast, NSW, Australia

Post by SLASH »

Hi Dicko,i had a dts kit fitted to my old 91 GQ with 160,000.Was fitted and tuned by Berrima diesel and ran 12psi,no I/C.Not sure what egt's were but it went really well,i loved it.Had no dramas at all.Had it for a few years and it got stolen with it and it was still going hard when it did.Cheers.
Posts: 169
Joined: Thu May 15, 2008 3:42 pm
Location: Central Coast, NSW, Australia

Post by SLASH »

Hi Dicko,i forgot to mention that it did get a flat spot higher in the rev range every now and then but i then fitted an electric fuel pump just after the tank and it fixed the problem.I thought it actually went better after i fitted it.Cheers.
Posts: 404
Joined: Sat Feb 24, 2007 8:52 pm
Location: hunter nsw

Post by ssfabricator »

what costs are you lookin at here for setup and install
If i just overtook you head to your nearest mechanic
Posts: 43
Joined: Sat May 28, 2005 3:33 pm
Location: Townsville QLD

Post by Dicko1980 »

I've seen the pistons and rods and they're definately different to the 95 onwards TD42's.

Cheers
dicko1980
twodiffs wrote:Pretty sure the heavier pistons were used in vehicles from 88-92?
and from 92 onwards on the turbo one's. Non turbo from 92 had the lighter pistons.
Dicko1980
Post Reply

Who is online

Users browsing this forum: No registered users and 123 guests