Can anyone show me a photo of the Bolt to tighten to adjust the torsion bar on a feroza???
Plz. Anyone.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Torsion Bar Adjustment
Moderator: Tiny
I don't have a pic, but it's easy to locate.
Simply follow the torsion bar back to where it attaches to the chassis. You'll find it roughly level with the rear edge of the front door.
Once you locate this, you'll see a bolt that is at right angles to the torsion bar.
The bolt has 2 nuts on it. You'll need 2 spanners, one for the lock-nut and one for the other, I think they're around 19mm from memory????
Simply loosen the lock-nut and then wind up the bar with the other nut.
Hope this makes sense...
Simply follow the torsion bar back to where it attaches to the chassis. You'll find it roughly level with the rear edge of the front door.
Once you locate this, you'll see a bolt that is at right angles to the torsion bar.
The bolt has 2 nuts on it. You'll need 2 spanners, one for the lock-nut and one for the other, I think they're around 19mm from memory????
Simply loosen the lock-nut and then wind up the bar with the other nut.
Hope this makes sense...
bru21 wrote:What happens in goat, stays in goat!
Who is online
Users browsing this forum: No registered users and 0 guests