Page 1 of 1
80 series 4 inch lift - how high does it sit?
Posted: Sun Nov 16, 2008 6:35 pm
by mudspinner
any one know how high an 80 series with 4" springs should sit?
how do you know how much above standard your vehicle is sitting?
Posted: Sun Nov 16, 2008 6:54 pm
by Weiner
4" higher then standard I'd say.
Measure distance from ground to guard breofr and after?
Posted: Mon Nov 17, 2008 6:33 am
by mudspinner
ok thanks,
maybe I need to be plain obvious, what is the total height.
i.e when messurded from the top of a rim to the guuard (with flares) what is that distance.
Posted: Mon Nov 17, 2008 5:06 pm
by rezpkt
Hi
Have a read through this thread;
http://www.offroad80s.com/how-high-is-y ... lit=height
These measurements are from center of hub to bottom of wheel arch flare.
We can all approximate our lifts from the figures below; I gathered these numbers from the previous posts.
Stock:
Front 520mm - Rear 525mm
2inch Lift
Front 560mm - Rear 570mm
4inch Lift
Front 645mm - Rear 670mm
6inch Lift
Front 690mm - Rear 725mm
Have fun.
Posted: Tue Nov 18, 2008 8:30 am
by Remydog05
Thanks rezpkt
Good info and reading
Posted: Tue Nov 18, 2008 9:22 am
by mudspinner
good info! thanks will see what my rig is sitting at now...
Posted: Tue Nov 18, 2008 6:01 pm
by crustybj60
thanks for that rezpkt!
just stumbled across this post.
pure gold.
crusty
rezpkt wrote:Hi
Have a read through this thread;
http://www.offroad80s.com/how-high-is-y ... lit=height
These measurements are from center of hub to bottom of wheel arch flare.
We can all approximate our lifts from the figures below; I gathered these numbers from the previous posts.
Stock:
Front 520mm - Rear 525mm
2inch Lift
Front 560mm - Rear 570mm
4inch Lift
Front 645mm - Rear 670mm
6inch Lift
Front 690mm - Rear 725mm
Have fun.