Page 1 of 1
Reco Head 80 series 4.5 Petrol
Posted: Wed Nov 19, 2008 8:13 am
by lux91
Guys/Girls
I've done the Head gasket on my 94 80 series 4.5 Petrol
Would someone be able to recommend a good shop to take the Head to have it checked and reco'd. Im on the north side of Brisbane
what kind of $$$ am I looking at?
I have already taken the head off and it has done nearly 200 tho.
Thanks in advance
Posted: Wed Nov 19, 2008 11:32 am
by RAY185
Go see Ken at Better Heads, he's a very good bloke, well priced and won't bullshit you. He's at Aspley so shouldnt be too far for you.
http://www.betterheads.com.au/
Posted: Wed Nov 19, 2008 1:05 pm
by dow50r
if u have overheated her, get the head serviced, if you have just noticed water disappear, i have seen people change the gasket and head bolts and drive off...but first, check the valve clearances...if they r in spec, your laughing.
Buy aftermarket good quality gaskets and head bolts...350 should see u right.
Andrew
Posted: Wed Nov 19, 2008 1:40 pm
by lux91
Thanks for the replies
RAY, I will call Better head later today thanks.
Andrew,
The car was missing really bad for a couple of weeks(it would come and go) then it just started pumping heaps of steam/smoke?? out the exhaust.
It did get hot at this point as i was trying to get the car of the main road...
I checked all the valve clearances before pulling the head off and they were all near the the upper limit (gregories manual) but i havnt measured any of the shims yet.
Cylinder 1 had alot of coolant in it but after removing the head it appears that between 2 and 3 had oil leaking and 6 appears alot worse??
