Outer Limits 4x4 Board

Have just finished doing a rebuild on the t/case and its still as noisy as it was before. So after some investigating iv'e noticed the input shaft has some play in it. Now while doing the rebuild i cant remember if there was a shim on the back of the input shaft.

Is it possible to replace these shims without completely dismantling the case?

Where can i get these shims from?


Cheers

B4T

you have to dismantle it again im afraid.... partially anyhow.

i have the shims , how much play are you talking about ? also is it lateral or longtitudinal play ?

did u replace they lay shaft?