Page 1 of 1
Transfer case swap from Gen I (89) to Gen II (92) Pajero
Posted: Fri Nov 28, 2008 5:10 am
by jfarsang
Has anyone done it ?
Would be nice to have superselect/activetrac on the ol' Paj.
Have an 89 NG 2.5
Thanks
Posted: Fri Nov 28, 2008 5:40 am
by J Top
Ive done the reverse, put an early t/c in my 94 to get more rear d/s length. It works but its not just bolt in, I had to drill one hole that didn't line up and the t/c lever is in a different place inside.
Posted: Fri Nov 28, 2008 5:50 am
by jfarsang
Was the speedo cable the same ?
I've read that the gen 2 uses a magnetic pulse input.
Posted: Fri Nov 28, 2008 6:26 am
by NJV6
Early 3.0 ones were cable and later ones were electronic.
You'd need to replace your auto hubs if you haven't already with either drive flanges so they were permanently in or put manual hubs on.
Posted: Fri Nov 28, 2008 7:03 am
by jfarsang
I've got manual hubs on already so that's taken care of.
I could always swap out the speed/gauge cluster and grab the 4wd control unit box behind the cd deck.
Posted: Mon Dec 01, 2008 10:21 pm
by spanky
so in theory i could get a t/f case of a gen 1 and put it on my gen 2 and run the pto winch? sounds too easy to be true
vaughan
Posted: Tue Dec 02, 2008 4:08 pm
by WACKO
spanky wrote:so in theory i could get a t/f case of a gen 1 and put it on my gen 2 and run the pto winch? sounds too easy to be true
vaughan
NJV6 reckons it can be done. im picking up my early transfur this weekend and already have my pto sitting the shed. when im doing it im going to take lots of pics and try and do a write up.
but if anyone has any tips or prior knowledge on it, let me know. im planing on just taking the PTO gear from the early case and putting it in my gen 2 transfur as the hole is already in the side.