Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Clutch throwout bearing getting stuck
Clutch throwout bearing getting stuck
Has anyone had troubles with the throwout bearing getting stuck. I couldnt disengage the clutch so i took the gearbox out and found the bearing gets stuck both engaging and disengaging the clutch, seems to get jammed up on the nosecone and you have to wiggle the bearing to get it moving back and fourth again. I have done the 1.6 conversion so it has to move an extra 6mm forward, but i dont think that would affect it, as it mainly gets stuck before it passes the end of the nosecone.
when replacing clutch thrust bearing etc you should clean all the old greese and crap off the slide and on the fork pivot and re greese. havnt seen one so bad that it wont let it return even a little. if its worn the inside of the thrust bearing on the plastic slide it can rooster and jam. same if the metal slide is aswell. could also be a combination of the above and worn clutch diaphram springs.
Who is online
Users browsing this forum: No registered users and 2 guests