Page 1 of 1
Bundy clutch change
Posted: Sat Mar 27, 2004 11:24 pm
by Skip
Took the Bundera down the drags a couple of nights ago and fried the clutch. Just wondering if I can change the clutch without removing the engine? Any tips or tricks anyone can offer?
Flogging R33 skylines is not worth melting a clutch
Posted: Sun Mar 28, 2004 12:46 am
by Evan
Beating skylines, way to go !
What times did it run ?
Sorry to hear about the clutch though.
Posted: Sun Mar 28, 2004 9:39 am
by Skip
Best run was 14.2, could have gone quicker if it wasnt for the clutch.
Posted: Sun Mar 28, 2004 11:20 am
by Ruggers
yeah it can be done and you dont even need to jack the vehicle as you can fit under it easliy. most times its easyier to unbolt the gearbox from the bellhousing the take out the gearbox then the bellhousing separate
Posted: Sun Mar 28, 2004 5:58 pm
by bundyboy
yeh, did it about three months ago.
Posted: Sun Mar 28, 2004 9:50 pm
by RUFF
Ruggers wrote:yeah it can be done and you dont even need to jack the vehicle as you can fit under it easliy. most times its easyier to unbolt the gearbox from the bellhousing the take out the gearbox then the bellhousing separate
This isnt possible with a Bundy as the bellhousing to gearbox bolts are inside the bellhousing.
Posted: Sun Mar 28, 2004 10:15 pm
by Skip
RUFF wrote:Ruggers wrote:yeah it can be done and you dont even need to jack the vehicle as you can fit under it easliy. most times its easyier to unbolt the gearbox from the bellhousing the take out the gearbox then the bellhousing separate
This isnt possible with a Bundy as the bellhousing to gearbox bolts are inside the bellhousing.
I was about to say that :(
Better start pulling things apart
Posted: Sun Mar 28, 2004 10:31 pm
by ORSM45
id go the gearbox and bellhousing out rather than the engine. either way wont be fun. but gearbox is easier.