Outer Limits 4x4 Board

Posted: **Fri Jan 09, 2009 5:28 pm**

Does the cooling system in the 2H need to be bled of air? As I notice there's a top bolt on the thermostat housing and some other coolant line:

Posted: **Fri Jan 09, 2009 6:33 pm**

Run it with the radiator cap off for a while. I've never noticed the bolt on top of the thermostat housing. Is it a mounting bolt? Or actually a bleed bolt?

Posted: **Fri Jan 09, 2009 7:31 pm**

From another thread;

Ruffy wrote:Hey stu,
Remove the heater hose off the highest fitting in the cylinder head. It is higher than the rad cap. Fill cooling system through heater hose until water comes out of fitting in head bleeding air out.

Dan

Outer Limits 4x4 Board

2H - bleeding the cooling system?

2H - bleeding the cooling system?