Page 1 of 1
75-60
Posted: Tue Jan 13, 2009 10:58 am
by Z()LTAN
Will my 75s HP center fit in a 60s housing?
Will my 75s ball ends fit in the 60s housing so i can use all my new 75s hubgear and longfeilds?
Posted: Tue Jan 13, 2009 11:16 am
by hulsty
The centre wont, the HP diff is a smaller diff than the 60 series low pinion front which is the same as your rear. Maybe if you used some kind of adaptor?
What kind of longfields are they? if they are 40 series ones they will fit straight into the 60 series balls you will just need the correct axels/length
Posted: Tue Jan 13, 2009 11:27 am
by hulsty
what are you trying to do by running the 60 front diff assembly? strength? width or something else?
cheers
Posted: Tue Jan 13, 2009 11:33 am
by Z()LTAN
the wider housing, the round axle tube
Be alot easier...
Posted: Tue Jan 13, 2009 11:37 am
by Z()LTAN
The only reason i want to keep the front dif and hubs is that they are all new and ive spent some good dosh on them b4 i knew better...
I spose ill run with it for now till something goes..
Posted: Tue Jan 13, 2009 11:55 am
by hulsty
I think the hubs should work fine on the 60 series housing, i'm using IFS hilux hubs on 70 series stub axels with 70 series discs and the free wheeling hubs were from a 60. Check the wheel bearing sizes to so if your later hubs will work on the 60 series stub axels
Re: 75-60
Posted: Tue Jan 13, 2009 3:36 pm
by bj on roids
Z()LTAN wrote:Will my 75s HP center fit in a 60s housing?
Will my 75s ball ends fit in the 60s housing so i can use all my new 75s hubgear and longfeilds?
NOPE!
YEP, if you cut the tubes and press it in!
