Page 1 of 1
v8 conversion, no injector pulse or fuel pumo??
Posted: Sat Jan 17, 2009 6:52 pm
by kegz
hey guys ive just done the holden 5 litre v8 out of a manual vr into my gq. its cum time to start and no go. ive used the bcm simulator is there a way i cantest? the pumps arnt working (no feed from green and white wire from ecu. and spark is very poor can only get minor spark from the coil and none to the plugs.
the dizzy is ok it flashes.
any help would be great
thanks
Posted: Sat Jan 17, 2009 7:00 pm
by zookster666
not sure what the problem is but i have the exact same problem with my tb42 efi i done the conversion got it wired and just today i was wheeling and all of a sudden engine coffed and spluttered then died no spark at leads no power to coil and fuel pump is dead
Posted: Sat Jan 17, 2009 7:59 pm
by zookster666
also at further inspection do you have power to coil i dont have any its got me stumped
re
Posted: Sat Jan 17, 2009 8:15 pm
by kegz
yes i have power at the coil + amd f;ashing at the - when cranking
have you checked all your basics like the fuses and connectors into ecu
re
Posted: Sun Jan 18, 2009 10:23 am
by kegz
problem found
i did not have a check engine light wired up, done this and all good, the coil is also shot so im going to put a new one in the hopefully it makes noise!!