Page 1 of 1
Reducing weight
Posted: Mon Jan 19, 2009 9:56 pm
by Wesley
Everyone is always going on about getting more power but ive never seen anything in here about reducing weight to gain performance and since weight is so important in a zook does anyone have any tricks to cut it down?
Posted: Mon Jan 19, 2009 9:57 pm
by atari4x4
i removed the sway bar & rear seats from my vitara.
Posted: Mon Jan 19, 2009 10:27 pm
by christover1
For a big weight reduction, I just get out.
And make sure I go to the loo, before getting in
Seriously.
I took 8" off the tub, and threw away my fibreglass roof,
plus no rear window glass and roof saves a lot of weight.
also no sway bar.
I also trimmed down the tools/spares I carry, to essentials only.
No carpets or interior trim helps a tad.
I only carry spare motor oil, as I could use in a diff/gearbox in emergency
Posted: Mon Jan 19, 2009 10:51 pm
by dank
http://www.outerlimits4x4.com/phpBB2/ft ... highlight=
This thread is gold for weight reduction. I am planning on running some comps in the future....whenever I get my zook back on the road....and we came up with a good list of weight reduction hints and tips...be aware its orietnated towards comps so some may affect road worthiness of the vehicle.
Posted: Mon Jan 19, 2009 11:04 pm
by zookimal
I'm trying to minimise weight in my current build and what I have to keep I'll keep as low as possible.
Posted: Tue Jan 20, 2009 12:02 am
by alien
back seats makes a huge difference - as does swapping out the front seats for something a little leaner.
rims would make a huge difference and tyre choice would also help, although this is weight down low.
a smaller battery would help too i suppose (ie: standard battery).
fibreglass bonnets are available (but very expensive and easily warped).
polycarb front windows can be had (but illegal)
i suppose you could go half doors or no doors...
tailgate is very heavy too, if youre not hanging a spare off it a fibreglass one could go there?
then you come to removing the fan/stereo/speakers/trim =) but honestly if you're going that far lay off the donuts for a few weeks and go for a run now and then!
other than that all thats left is "speed holes" =)
Posted: Tue Jan 20, 2009 6:46 am
by grimbo
be careful though as taking too much weight off will affect traction. On my old Zuk we had to make the rear tray heavier than the stock tray was as we found that the additional weight over the rear wheels improved the traction and handling
Posted: Tue Jan 20, 2009 7:29 am
by 11_evl
dank wrote:http://www.outerlimits4x4.com/phpBB2/ft ... highlight=
This thread is gold for weight reduction. I am planning on running some comps in the future....whenever I get my zook back on the road....and we came up with a good list of weight reduction hints and tips...be aware its orietnated towards comps so some may affect road worthiness of the vehicle.
Thats a very interesting thread, i remember reading it ages ago.
steve put some very good but time consuming
info
Posted: Tue Jan 20, 2009 10:11 am
by GRPABT1
Like grimbo mentioned evening out the weight is important. A ute chop will save alot, but the engine bay is where you want the savings, so tube bars, whinch rope, re-located batteries etc are all good things.
Posted: Tue Jan 20, 2009 2:53 pm
by ZUKPOWER
GRPABT1 wrote:Like grimbo mentioned evening out the weight is important. A ute chop will save alot, but the engine bay is where you want the savings, so tube bars, whinch rope, re-located batteries etc are all good things.
a ute chop will add to the weight of the zuk as any tray you build will way more than the original paper thin body did
Posted: Tue Jan 20, 2009 3:08 pm
by christover1
Moving my fuel tank forward of the axle helped with balance when climbing.
Posted: Tue Jan 20, 2009 3:47 pm
by GRPABT1
ZUKPOWER wrote:GRPABT1 wrote:Like grimbo mentioned evening out the weight is important. A ute chop will save alot, but the engine bay is where you want the savings, so tube bars, whinch rope, re-located batteries etc are all good things.
a ute chop will add to the weight of the zuk as any tray you build will way more than the original paper thin body did
But factor in lack of seats, soft top and that you can build a light tray and you will find it's lighter.
Posted: Tue Jan 20, 2009 4:35 pm
by mrRocky
most of the weight is in the cab, its all double , tripple and quadroople skinned, speed holes everywhere, and remove a layer here and there would do the trick, but the bodies are pretty flimsy as it is.
Posted: Tue Jan 20, 2009 4:58 pm
by Wesley
Posted: Tue Jan 20, 2009 5:14 pm
by mrRocky
u r ghay
Posted: Tue Jan 20, 2009 6:01 pm
by MUD-PIGSIERRA
Battery is in a sealed box behind passenger seat, instead of sitting bonnet height, plus don't know about you guys but battery's in the NT generally only last a year or so with the heat. I have not had to touch the battery since I have got my Sierra or clean it or anything it stays clean and away from the elements.
Oh I put my axles under the springs so they are even closer to the ground lower COG.....