I replaced the rear wheel bearings of my 84 MQ today but I ran into a problem! When I placed the axle's back in the rearend and thighten the 6 nuts of the RH side (short axle) the bearing got way to tight! It looks like I need at least 50 shims to get it the way it supose to be! The left side didn't need any shims and this bearing feels tight.
Did I do anything wrong? Please help me out!
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Wheel bearings MQ
Wheel bearings MQ
Patrol 2.8 '84, twin carburators, Z-car header, 280ZX cam, SPOA, ARB lockers f+r, Ramsey winch, 33" Maxxis Mudders and some rust....
Who is online
Users browsing this forum: No registered users and 3 guests