Page 1 of 1
Transfer swaps
Posted: Mon Apr 05, 2004 5:19 pm
by -Mick-
I'm looking at buying a S3 in 1.3 case ready to go and putting it in my lwb which has the 1l driveline.
Is it just the xfer mounts that are different? Will it bolt up otherwise?
I did a bit of a search but I'm feeling lazy
Cheers
Posted: Mon Apr 05, 2004 5:23 pm
by CHOPZUKI
i dont know
Posted: Mon Apr 05, 2004 5:28 pm
by zooki
The transfer ounts are different but the one off your 1 litre case will fit on the new transfer.
The big problem is the driveshaft flanges are different so the driveshafts won't fit and depending on what model youe 1 litre is you may or may not be able to change the flanges over as there are 2 different spline sizes, I think the change was in 84 the same as when they changed the internals.
Posted: Mon Apr 05, 2004 5:35 pm
by N*A*M
buy the case
swap the arms and flanges
if they don't swap over, sell the case again
Posted: Mon Apr 05, 2004 11:01 pm
by antt
buy it mj, then if it doesn't fit, give it to me so i can dual case the vit
Posted: Tue Apr 06, 2004 8:39 am
by -Mick-
Posted: Tue Apr 06, 2004 9:59 am
by greg
If possible - find out what year the x-fer case is out of - that will tell you what flanges you need to mate up to it (widetracks came with two different sized flanges - do a search - there's a thread about it). Then it's just a simple matter of knocking out some unis and hooking it all up again.
