Rear wheel carrier ?
Posted: Mon Feb 16, 2009 7:28 pm
Anyone know of a supplier of an axel and bearing Assy to weld on to a home made wheel carrier or what else have you used?
cheers
cheers
Page 1 of 1
Posted: Mon Feb 16, 2009 7:32 pm
getting a shaft turned up to suit a trailer bearing sems to be the one of choice, cheap readily available bearing set
Posted: Mon Feb 16, 2009 8:15 pm
Someone posted this here recently and I saved the link for future use, they may have weldable ones,
http://www.trailerparts.net.au/
Cheers
http://www.trailerparts.net.au/
Cheers
Posted: Mon Feb 16, 2009 10:42 pm
It's got me beat why people have to have a set of bearings in a wheel carrier. It only has to rotate a very small amount, a bush is the way to go I recon... simple, strong and long lasting....but what would I know...
Posted: Mon Feb 16, 2009 10:56 pm
trailerparts.net is the way to go.
Bearings are better than using bushes in my opinion, and for the price, why wouldn't you?
I picked up my gear for under $50. Flangeless hub, bearings, split pin, seal and bearing cap.
You might save a few dollars using a bush, but in the scheme of things, what's a few dollars?
Bearings are better than using bushes in my opinion, and for the price, why wouldn't you?
I picked up my gear for under $50. Flangeless hub, bearings, split pin, seal and bearing cap.
You might save a few dollars using a bush, but in the scheme of things, what's a few dollars?
Posted: Tue Feb 17, 2009 7:25 pm
Cheers guys,
Just what I was after
Just what I was after