Outer Limits 4x4 Board

does anyone know were to get exhaust pipe from because i would like to make my own system and my local steel place only does structural steel im in ipswich

exhaust shop should sell it to you per meter

dirty dirty 4x4 wrote:does anyone know were to get exhaust pipe from because i would like to make my own system and my local steel place only does structural steel im in ipswich

If your planing on using the new bender you bought to bend your exhuast pipe, i doubt it will it will most likely just kink because the stuff for exhaust's is too thin they use a draw through still bender to bend this stuff. Sorry if i've put a downer on it for ya

as above.
you can buy preformed mandrel bends and cut these to suit and weld them to lengths of pipe. But if you are looking at doing this to save a buck, by the time you buy pipe and bends at retail price you may as well pay to get a system made for you unless you particularly want to build your own.

80's_delirious wrote:as above.
you can buy preformed mandrel bends and cut these to suit and weld them to lengths of pipe.

Yep. Mandrel bent sections in tight/loose radius, 45/90/360 degree sections can be had for around $15 a piece. I get mine from the local truck shop.

Exhaust pipe comes in 3M lengths and is pretty cheap. If you have the tools and the time (and patience), you can make a fantastic system and save yourself a fair whack of coinage too!!

ebay.

nahux is the seller (link)

send him a message asking to bulk discount on the shipping, if the size you want isn't listed, just ask him if he can get it