Outer Limits 4x4 Board

ive managed to strip a stud. i am now having a hard time finding a replacment. just wondaring if anyone know/has/can get some studs

needs to be about 10mm threaded then go into a non threaded part for about 10mm then the reast doesnt matter too much. i will post up a pic tomrow

basicly somthing like this

/////|||||////////////////

any bolt place should be able to help you

what is it out of? If its an engine, most engine rebuilders will have them

As Bogged said above or get some rod and get busy with a die.

I have a couple each of 10x1.25 both ends or 10x1.25 - 10x1.5 just put in the car. collect tomorrow from Homebush 0700 - 1530 or from Seven Hills after 4pm.


email before 0600 tomorrow or shoot me a txt 0404016235 if you want them.

need threaded studs (metric fine)

So, you're after a neatly dressed asian/european???

ive managed to strip a stud.

Depending on your orientation this could be a positive.

Seriously, they generally come in standard sizes and most pitches, and should be available from most nut/bolt distributors, eg Boltbarn.

Try a repacement wheelstud from Nissan/Toyota/Mazda/et al

Is it a wheel stud or a manifold stud? Repco carries alot of that stuff and most of the time they have vehicle specific listings, give them a call or give us some more info.

most bolt shop dont keep them........................

any exhaust shop keeps a shit load of studs for manifolds................

is just a custom thing so its not off anything spasific. will try an exhaust shop.

thanks