Page 1 of 1

TB42e Fuel Pressure Reg

Posted: Sun Feb 22, 2009 10:22 am
by Jimbo
Around 3 months ago i burst a line from the fuel pump on top of the tank. I didnt have time to replace it then so i just pulled pump fues out and ran on LPG.

Anyway i dropped the tank yesterday and fixed the line, hooked it all up and NOTHING. Pump still works and seems to have pressure but not running on petrol.

There is fuel all the way to Fuel reg but when i took of the return line from the fuel rail there is nothing!!

Pulled off fuel reg and there was some crap in there that looked like the inside of the old fuel line (I replaced all the fuel lines). I pulled that out but the reg is still not letting fuel through.

Anyone else had a similar problem. Where can i get a fuel reg from? I rang repco but they dont even have them on their system. Can i go aftermarket???

Cheers

James

Posted: Sun Feb 22, 2009 3:21 pm
by Jimbo
Just hooked fuel line up to guage and there is 90 psi!!! I also swapped FPR over with one from a skyline and still no fuel getting past reg....Whats going on???

Posted: Sun Feb 22, 2009 3:47 pm
by Quadcamshorty
I just read the original post again and it seems like you have alreedy checked the return.

Posted: Sun Feb 22, 2009 5:57 pm
by Jimbo
Stupid me hooked the lines up back to front :(

Thanks anyway