Page 1 of 1
Modified low mount winch
Posted: Sun Mar 01, 2009 8:52 pm
by 4wheelsdriven
Has anyone looked into or done any mods to a low mount winch. I was hoping someone on the forum may have made a bigger drum or modified the pins at the back of the winch that break off if the cable spools to one side. Any pics or ideas would be great.
Posted: Sun Mar 01, 2009 9:19 pm
by turps
Yep all been done.
A mate has had an alloy plate across the back being used as tie-bars for yrs.
But there are now some guys in QLD with a modded lowmount that is faster than a himount.
Posted: Sun Mar 15, 2009 1:15 am
by Breaker Brother
turps wrote:Yep all been done.
A mate has had an alloy plate across the back being used as tie-bars for yrs.
But there are now some guys in QLD with a modded lowmount that is faster than a himount.
anymore info on this ?
Posted: Sun Mar 15, 2009 12:19 pm
by hoppy's79
Russel at ARB in rockhampton does these highly modified low mounts, pretty sure he's running 2 6hp motors running 24volt, pneumatic free spool etc. faster than highmounts think he sell's the whole setup for around 6k