Outer Limits 4x4 Board

i read somewhere that this was being done a bit. am fitting gq diffs to my g60 with mq 5 speed. would like to keep the same offset. i cant find the original post. thanks in advance ray

So you wanna put a GQ centre into a LC60's housing to keep the offset?

Why not use the the LC60's gear completly?

WICKED wrote: Why not use the the LC60's gear completly?

exactly?

or MQ diffs....

he may not want the TLC junk in his Nissan!

or maybe he just has the GQ ones laying around...

ok prob should give a better explanation. i already have mq arb'd 4.6s in it.
I recently went from 35x12 trepadores to 37x14.5 creepys and am now finding a lot of tyre rub. i should have installed wider diffs before but now need them. i have gq 4.1s front and rear diff and also have a set of 60 series diffs laying around. i also have a tight mk lsd in a 4.6 center. while i would like to retain all nissan bits . i would like both pumpkins in the same offset idealy for ease of driveshaft angles . my original plan was mod the rear mq locker to fit a gq front and leaf spring it. if i was to retain 4.1s i would just use gq front and 60s rear but i like my 4.6s. what i read went along the lins of comp guys are using patrol centers because lc centers are weak so they use troll ones by swapping locker splines. have searched and cant find anyone who makes a 4.6 for a lc or a 4.5 for a troll. 4.8s are too for me and 4.3s to low. any other suggestions for better geared wider diffs. oh and as for toyota bits in my nissan I'd prefer not to but i do like the idea of wheels not flying off when you snap a rear axle. (its scary on the high way) thanks

I've got a GQ Leaf diff with an MQ centre and AirLocker in the front my MQ. I've not broken it yet but it worry's me.

Time again 60's front, Less to worry about.


As for gearing for the LC stuff ask/look at www.locktup4x4.com.au

cheers wicked. why would you 60s the front? so you can longfield it? how did you make the center fit? when i look at the front gq and rear mq gears are oppisite directions. i hope im wrong.

g60ish wrote:cheers wicked. why would you 60s the front? so you can longfield it? how did you make the center fit? when i look at the front gq and rear mq gears are oppisite directions. i hope im wrong.

It's the MQ 3rd Member, gear's, C/w&P and Locker in a GQ leaf housing. See if I can find it for you...

any luck finding pics or links bud?

try in here.

http://www.outerlimits4x4.com/phpBB2/ft ... asc-90.php

thanks

thanks

Thanks for that Nasty.

There is a thread somewhere explaining how I did it, somewhere. Just can't find it! LOL

Hope the pic's answer your question