Outer Limits 4x4 Board

Hey All Yes I should search but due to trying to get my Vit ready for TT I need yas Help .......

As Post states I'm after the wire colour codes to Pin locations on the plug that fits into the air flow meter ....


Just checking as I have had to lengthen the wires due to running the intake into the cab and running a POD filter under the dash .... ( I also done away with that air chamber doodad that hangs off the side of the intake pipe ...? this wouldnt cause the rig to run like a bitch coughn and spluttering ??? so I want to check I didnt fark up the re wire of the plug ...


Thanks

Dan

when u removed the air chamber thingo did u block it up?

as when i took that off mine but otherwise stock it would stall out. and not easy to start.

what airflow meter do u have? how many pins in there. (roughly what age motor also)

Yes blocked up the hole with a stainless Bung I made...

um Im at wrk doing sum stuff for the rig ....I would say about 6pin at a guess


Year of car / Donk 94


cheers for the reply Nic ,



Dan

pm me your email address and i'll email it to you, so you can zoom on the image with pics and fax viewer

Thanks Jason

thats the one.

theres also a later version diagram but think it is only a 4 pin

Well i was right it was the A/F Meter ...but wasnt wired incorrectly ...seem as though when I must have been putting the corrugate tubing over I must have pulled one the wire (well actually broke) one of the wires .....fixed that and it fired back up with its crispy sound ...hoepfully all stays well ova the weekend


thanks again for the info