Page 1 of 1
About HD-E distributor
Posted: Tue Apr 13, 2004 10:40 pm
by nozik
Hi, all!
I live in the Minsk of Belorussia & have a Feroza HardTop (F300) 1991
My question: What are the dimensions of rubber “O”-ring at distributor?
Thanks!
Posted: Wed Apr 14, 2004 12:25 am
by murcod
Hi, are you talking about the O ring that seals the distributor shaft into the engine's head (ie the oil seal)? Or the rubber gasket that goes between the distributor's plastic cap and alloy body?
re
Posted: Wed Apr 14, 2004 12:43 am
by nozik
Exactly - "O" ring that seals the distributor shaft into the engine's head
oops...
Posted: Wed Apr 14, 2004 12:50 am
by nozik
Image insert problem...
Posted: Wed Apr 14, 2004 1:35 am
by murcod
Try removing the spaces in the image name.
I'll grab my vernier callipers later tomorrow (today? it's 1am here....) and measure the o ring on my spare distributor.
Re
Posted: Wed Apr 14, 2004 1:48 am
by nozik
Thank you, David! I will wait!
Posted: Wed Apr 14, 2004 12:01 pm
by murcod
OK, bearing in mind that the o ring on mine is used and flattened out a bit:
The outside diameter is 37.0mm, the diameter of the rubber forming the o ring is ~ 3.5- 4mm. It's hard to give accurate measurements due to the o ring being deformed.
The actual distributor shaft measures 36.0mm max and 30.0mm where the o ring sits- so the above figures for the o ring should be right.
Thank you!
Posted: Wed Apr 14, 2004 5:03 pm
by nozik
Thank you, David - HEARTLY!