Page 1 of 1
what is this diff???
Posted: Mon Apr 06, 2009 6:14 pm
by ajsr
hey guys
can someone tell me what this dff center is out of ???
it fits in my nt and wide track housings.
its 3.9 ratio 43 crown teeth and 11 pinion.
and its 26 spline rear.its not narrow track I dont think as its different to the ones I have.
Posted: Mon Apr 06, 2009 6:19 pm
by r0ck_m0nkey
Looks like an SJ80 rear diff.
It won't work in anything else but a coily, so to save any potential issues, just send it to my place so i can dispose of it.
Posted: Mon Apr 06, 2009 6:29 pm
by ajsr
r0ck_m0nkey wrote:Looks like an SJ80 rear diff.
It won't work in anything else but a coily, so to save any potential issues, just send it to my place so i can dispose of it.
whats the difference???
and why wont it work??
Posted: Mon Apr 06, 2009 6:56 pm
by r0ck_m0nkey
ajsr wrote:whats the difference???
and why wont it work??
The difference is it has bolt holes on the casing for a rubber vibration dampner thingy and flange bolt holes may be bigger???
As for why it won't work, simply because an air locker in the back of mine is a better idea then an air locker in the back of yours.
Posted: Mon Apr 06, 2009 6:58 pm
by Gwagensteve
Should be fine.
Steve.
Posted: Mon Apr 06, 2009 7:17 pm
by ronoor
does he know this has a airlocker .lucky bugger.cheers ron
Posted: Mon Apr 06, 2009 7:21 pm
by 31zook
Look, if you send it to me ill check, that way you'll know it would of fitted and now ive got fancy blue diff breather hoses...
seroiusly tho, check for the part number on it and refer to tha ARB manual
Josh
Posted: Mon Apr 06, 2009 7:44 pm
by ajsr
ronoor wrote:does he know this has a airlocker .lucky bugger.cheers ron
yes you farkers he knows its an air locker
I bought it from QLD both front and rears no more lockrights
the front is narrow track and it appears the rear is coily.
if I told you how much for the lockers and compressor you would really be jelous.
Im just hopefull the center is able to be used in my wt diffs.
checked the arb web site the lockers are the same so at worst ill have to put the locker im my old nt center.
Posted: Mon Apr 06, 2009 8:08 pm
by Gwagensteve
Both third members should just bolt straight in - why swap the airlocker centre over? I can't see why the coil third member won't bolt in, the only difference is the bolts for the vibration damper AFAIK.
Steve.
Posted: Tue Apr 07, 2009 7:57 am
by lay80n
100% a coiler rear 3rd member will bolt in to a WT housing. I have done this before after smashing a rear diff and needing to get the zook going again.
Layto.....