GU ute chop pressing
Posted: Sat Apr 11, 2009 3:57 pm
hey any on know wehe i can bye a pressing to sute a gu patrol dual cap
HUH?gupootrol wrote:hey any on know wehe i can bye a pressing to sute a gu patrol dual cap
Page 1 of 1
Re: GU ute chop pressing
Posted: Sat Apr 11, 2009 7:39 pm
Re: GU ute chop pressing
Posted: Sat Apr 11, 2009 7:49 pm
again, phew, its not just me that cant make sense of it.Bad JuJu wrote:HUH?gupootrol wrote:hey any on know wehe i can bye a pressing to sute a gu patrol dual cap
wondering if he means rear wall.. then again, he could mean inner guard rubber.
Re: GU ute chop pressing
Posted: Sat Apr 11, 2009 7:53 pm
theres rules against this now!!bogged wrote:again, phew, its not just me that cant make sense of it.Bad JuJu wrote:HUH?gupootrol wrote:hey any on know wehe i can bye a pressing to sute a gu patrol dual cap
wondering if he means rear wall.. then again, he could mean inner guard rubber.
Re: GU ute chop pressing
Posted: Sat Apr 11, 2009 10:38 pm
Again HUH ?mickyd555 wrote:theres rules against this now!!bogged wrote:again, phew, its not just me that cant make sense of it.Bad JuJu wrote:HUH?gupootrol wrote:hey any on know wehe i can bye a pressing to sute a gu patrol dual cap
wondering if he means rear wall.. then again, he could mean inner guard rubber.
Re: GU ute chop pressing
Posted: Sun Apr 12, 2009 7:15 am
I would decode that as a rear wall for a duel cab gu patrol.gupootrol wrote:hey any on know wehe i can bye a pressing to sute a gu patrol dual cap
I'm not sure who makes them anymore, a company I did work for bought them in but the bloke that made them retired and sold all the jigs.
You could try kustom kages, Heres a pic of his work. http://carl.outerlimits4x4.com/ftopic16 ... highlight=
Re: GU ute chop pressing
Posted: Sun Apr 12, 2009 8:23 am
http://www.outerlimits4x4.com/phpBB2/ftopic17587.phpBad JuJu wrote:Again HUH ?mickyd555 wrote:theres rules against this now!!bogged wrote:again, phew, its not just me that cant make sense of it.Bad JuJu wrote:HUH?gupootrol wrote:hey any on know wehe i can bye a pressing to sute a gu patrol dual cap
wondering if he means rear wall.. then again, he could mean inner guard rubber.
Posted: Sun Apr 12, 2009 9:44 am
im doing a dual cab cut and im after the pressing with the corners ready to weld
Posted: Sun Apr 12, 2009 10:19 am
Mickyd555 
gupootrol - Thanks for the clarification.
The only oes I know about were fully fabricated by a sheet metal shop or an actual ute cab was cut up and used.
gupootrol - Thanks for the clarification.
The only oes I know about were fully fabricated by a sheet metal shop or an actual ute cab was cut up and used.