Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

UHF problems please help

For all things Electrical.

Moderator: -Scott-

Post Reply
Posts: 653
Joined: Tue Feb 17, 2009 9:48 am
Location: Mt Isa QLD

UHF problems please help

Post by Kingston_99 »

ok my UHF works fine i can hear people clear and dont cut out, but sometime mates say i cut out when i talk. they say sometimes they only hear 2 words out of an entire sentence.

i just changed my aireal to the fiber glass ones, also my hand piece (the mic), the cord on it that protects the wires from the outside as split and has started to fall apart and expose wires.

im going to get a new hand piece and see wat happens.

has anyone else had this problem and wat did u do?
Posts: 653
Joined: Tue Feb 17, 2009 9:48 am
Location: Mt Isa QLD

Post by Kingston_99 »

Eddy wrote:check all the wires and make sure they not rubbing against the body.
check your earth many problems caused by bad grounding of the radio body to the veh8cle
make sure the airial has a good earth tooo
ok from what u said, thanks will look at it tomorrow
Posts: 1048
Joined: Sat Jul 17, 2004 9:48 am
Location: Waikerie; SA

Post by Eddy »

:rofl:
'03 Mazda Bravo Plus
'80 Datto 720 Ute
'77 Leyland Terrier Truck ... yes a real truck
God of Athiests
Posts: 8336
Joined: Thu Aug 07, 2003 2:14 am
Location: Brownsville

Post by DamTriton »

Let me guess, you have bought a big long fibreglass one because "bigger is better"?

Have a look at your mates antennae (plural ;) ) and see if they have the short stubby ones.

Lesson one with UHF antennae, the longer they are the worse they will be in hilly territory, but the better they will be on the freeway. Conversely the short ones are better in hilly territory, but don't have the range on the highway.

This results from the radiation pattern (think "splatter" pattern) of each of the antennae. The short ones have a pattern like a holey donut cut in half (figure of 8) whereas the long antennae are more like that donut after you have sat on it (more disc shaped). If you compare the shapes and take the logical approach that there is the same area of radiation in both patterns you realise that the long antenna will be a lot wider in diameter (hwy), but the short antenna will have better transmission off the horizontal centerline (hills). (Two wide very flat ellipse vs a big "00")

Not discrediting any of the above comments about power and earths (especially earthing the base of the antenna) as they could also be the problem.

Has one of your mates got a mike (same radio as you??) you could swap for a trip to see if it is the problem?

Don't go spending money until you have at least tried to check the easy stuff.
George Carlin, an American Comedian said; "Think of how stupid the average person is, and realise that half of them are stupider than that".
Posts: 653
Joined: Tue Feb 17, 2009 9:48 am
Location: Mt Isa QLD

Post by Kingston_99 »

yeah i been told the white aireals arnt as good as the wire ones, but im up in weipa and theres no hills, plus also i didnt get the big long one, i got the real fat one thats short.

by earthing between aireal and base (bull bar). will the paint disturb it abit?
God of Athiests
Posts: 8336
Joined: Thu Aug 07, 2003 2:14 am
Location: Brownsville

Post by DamTriton »

Kingston_99 wrote:yeah i been told the white aireals arnt as good as the wire ones, but im up in weipa and theres no hills, plus also i didnt get the big long one, i got the real fat one thats short.

by earthing between aireal and base (bull bar). will the paint disturb it abit?
More important that the coax has good connections to the antenna base. It would be a good idea to help things along by making a good connection between the base and the bullbar by scraping down to the metal where the base touches the b/bar.

Also run you radio power direct from the battery and away from other wiring.
George Carlin, an American Comedian said; "Think of how stupid the average person is, and realise that half of them are stupider than that".
Posts: 653
Joined: Tue Feb 17, 2009 9:48 am
Location: Mt Isa QLD

Post by Kingston_99 »

looked behind the UHF today and tidy up all the wires behine the uhf and seam to have done the trick so far, i stilll have to get a new hand peice but.

thanks for the help guys
Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests