Outer Limits 4x4 Board

Posted: **Fri Apr 17, 2009 12:52 pm**

I'm looking into installing a couple of oil senders (pressure and temp) on my J20A GV. I was going to use a sandwich plate but the clearance looks a little too close, maybe 1" from the engine mount. I think the sandwich plate is 1.5" thick.

Has anyone installed a sandwich plate on a J20A in a GV before? Are there any other options if it won't fit that are quick,easy and cheap?

I have an image on flickr but I can't seem to upload it correctly.

[img]http://farm4.static.flickr.com/3608/344 ... 80.jpg?v=0[/img]

Cheers,
Ben

Posted: **Fri Apr 17, 2009 1:54 pm**

their you go
get rid of ?v=0 after .jpg

can you get a shorta oil filter

Posted: **Fri Apr 17, 2009 2:05 pm**

hillbilliywheelchair wrote:
their you go
get rid of ?v=0 after .jpg

can you get a shorta oil filter

Thanks for the tip about pics.

Will look into getting a shorter filter, but doesn't that reduce the capacity of the filter then?

Posted: **Fri Apr 17, 2009 3:31 pm**

just change it more frequently than factory intervals, most enthusiast do anyway

Posted: **Fri Apr 17, 2009 3:59 pm**

have you thourght about a 90 deg' adaptor which turns your filter on its side

Posted: **Sat Apr 18, 2009 11:29 am**

Why not just put a T-piece on where the original sender is now for the new senders unit?

Wouldn't that be easier?

Posted: **Sat Apr 18, 2009 8:49 pm**

Jock wrote:Why not just put a T-piece on where the original sender is now for the new senders unit?

Wouldn't that be easier?

Good point. You wouldn't happen to know where the sender is would you?

Outer Limits 4x4 Board

Will an oil filter (sandwich) adaptor plate on a J20A fit?

Will an oil filter (sandwich) adaptor plate on a J20A fit?