Page 1 of 1
Shortening a 9 inch Brisbane
Posted: Thu Apr 23, 2009 8:19 pm
by sloshy
Who does this around brizzy?
I will need my axles resplined as well.
What sort of coin is it worth?
Posted: Thu Apr 23, 2009 8:29 pm
by ISUZUROVER
buds4x4?
Posted: Sun Apr 26, 2009 1:44 am
by berad
http://www.superformance.com.au/
its at capalaba, a mate had a 9inch modified to fit a vk, and stronger axles machined up there, the new axles compared to standard are a level above the rest, beefed right up.
Theres also a place at brendale which does the same stuff but further away from you.
Any rod shop, or serious rotar race team/shop will be worth a ring for a quote.
Posted: Sun Apr 26, 2009 8:31 am
by nastytroll
there was a place down the gold coast my bro used years ago too.
Posted: Sun Apr 26, 2009 10:35 am
by nottie
http://www.qpaac.com.au/index.php
Queensland performance axels and components
Posted: Mon Apr 27, 2009 11:33 am
by CRUSHU
Cut down & Resplined axles are weaker than stock axles, as the hardening isn't replaced.
Aftermarket alloy axles will be $600 - $900 depending on quality, complete.
My guy charges $350 to shorten the housing.
Posted: Mon Apr 27, 2009 9:23 pm
by sloshy
Just need the housing shortened now I am getting some after market axles, don't know what brand yet though, any recommendations?
Posted: Mon Apr 27, 2009 9:53 pm
by CRUSHU
Moser are the best, from Supa Trik engineering in Melbourne. Good warranty too. It is a replacement warranty, of the next size up. He can shorten your housing too.
Posted: Mon Apr 27, 2009 10:23 pm
by sloshy
Was leaning towards moser axles, a few mates run them in 11 sec cars with no dramas.
Posted: Tue Apr 28, 2009 12:16 am
by I.M.P.O.S.E
How short are you looking to go with the housing?
Posted: Tue Apr 28, 2009 4:54 pm
by sloshy
I.M.P.O.S.E wrote:How short are you looking to go with the housing?
40mm a side.