Outer Limits 4x4 Board

G'day all. Just wanted to know as i want to put gq front axle in (for now) and not sure if the ratio's are the same. i know the poos are 3.9

Theres a few variants in the Surfs, you'd have to confirm with your axle code listed on the plate under the bonnet. Theres a website you can look it up on.

Most common were 4.56 and 4.88 from memory.

Outer Limits Hilux wrote:G'day all. Just wanted to know as i want to put gq front axle in (for now) and not sure if the ratio's are the same. i know the poos are 3.9

Why pootrol?

wont they be heaps wider than the rear?

i used a 79 series front it is the same width as your ifs rear

if you put an airlocker and a set of aftermarket ring and pinion and long feilds it is tough as

Because the gq diff is all ready to go. and 79 series diff is hard to come buy and if you do get one they won't be as cheap as a gq.

$500 each is not bad at all.

Just one other prob, anyone know how or where i can get my guards flared. they look mad when done prop, could you just drop them into a fibreglass shop and get them to fab it???

like this

this is my new truck with an 80 front end















i have the molds
i am going to make some urethane ones with scrub bars inside

Outer Limits Hilux wrote:Because the gq diff is all ready to go. and 79 series diff is hard to come buy and if you do get one they won't be as cheap as a gq.

$500 each is not bad at all.

i paid 650 for a 79 front end in brisbane 2 years ago it had 4.3 diff gears in it
just bolted on some 80 series knuckles an bobs your uncle

good for the stock look