Outer Limits 4x4 Board

Hi guys i have a problem with the rear brakes of the lux , i have adjusted them up and bled them and am still having trouble with them not working well ,
crawled under the back and there is a sort of cylinder mounted up under the tray that the brake line goes to then down to the diff , there is also a rod connected to the back of the diff that goes up to this cylinder .
is this necessary ? or could i remove the cylinder and just run straight brake line to the diff then out to each wheel
or is this cylinder a distributer or something? rod looks like it pumps up the cylinder when the diff moves ??

Its the load sensing valve so when you have higher loads in the rear, more braking is applied to the rear. This should be bled as well.

thanks , probably my problem .

Are there any issues with replacing the LSPV with a bias valve from Wilwood or similar?

yamaha__308 wrote:Are there any issues with replacing the LSPV with a bias valve from Wilwood or similar?

yeah its illegal!
just cut it and zip tie it to the top so all the brakes go to the rear

if you have lifted your car you need to extend the arm to make the breaks work