Outer Limits 4x4 Board

during putting my 4 inch lift under my shorty we had to remove the petrol tank as we needed a bent control arm. have recently bolted arm and tank back in but my tailshaft now hits the tank during artic. why does it only do it now? never used to do it with the 2 inch lift. i might have to re adjust the panhard but even then it will be running very close to it
anyone else had this?

yeh adjust pannard, same thing happened to mine

If it flexes well you will get a lot of rear steer which will drive the pinion into the tank.

I had this happen to my truck, fixed it with a long arm kit and moded the tank as well.
Hope this helps

Michael.

i put in a 5 inch efs lift, i needed to chop the hell out of my tank, and i used the std upper trailing arm, was a bit sceptical about the bent ones you can buy.. i.e. strength and the possibility of incorrect distances of the bushes to match the std one on the other side.

i ended up welding in some box section into the tank for the trailing arm to 'flex into' and cutting 20mm off the inner length of the tank to clear the uni's..

i have also flipped my tailshaft to stop the larger uni hitting on the crossmember when flexing. hence having to take so much off my tank.

how do u go about washing fuel tanks out before chopping them up? wat do u wash them out with? i hav never tackled it before.