Outer Limits 4x4 Board

gday my rx has a slight vibration from take off i've been told its the pinion angle where the car has been slightly lifted(4") and that adjustable lower control arms will fix this, (if you look at the tailshaft you can see where the tube that goes in to the rubber seal is being pulled out further than on a standard car) has anybody had this problem and solved it? cheers

Replace you lower control arms with 16mm longer H/D control arms and vibration will go away

Ive got 3.5inch lift in my shorty had bad vibrations till i got up 80kmh and they went away.
But once i put 16mm longer control arms in the vibrations went away 4 good.

Can bye adjustable control arms but will cost heaps or just bye 16mm longer control arms for about $130 for a pair

i put adj lower arms in my lwb got no vibrations at all ,pinion angle is sweet but i am looking to get my tailshaft lengthened slightly to give me more/standard travel in the slip joint .

cananyone tell me how much i need to extend my rear lower control arms to suit a 4 inch lift in my shorty? was going to go 20mm but evryone seems to go 16mm

+ 16mm will be fine

cheers guys

jet-6 wrote:+ 16mm will be fine

Will these work with a 4-5inch lift in a GU wagon