Outer Limits 4x4 Board

I'm doing a power steer conversion on a sierra, fitting a vitara pump and jimny hydro assist box with a 1.3 engine and standard radiator/ radiator supports. Can anyone help me with photos on radiator support clearance to vitara pump pulley? I have looked in the sierra bible but didn't see any posts on this conversion. Thanks, Jeff

I don't think it will clear. I've worked on a 1.3 LWB with a 16V vitara motor and a stock vitara PS pump - the radiator support bracket on the chassis was cut to clear the pulley.

Not 100% though.

Steve.

agree.

when i dummied mine up there was about 5mm clearance and that was not taking in engine movement etc

Hey Steve, I've done a quick mock up without bolting up the mounting bracket and pump. It looks like it will clear the chassis mount for the radiator support but the actual radiator support arm is definitely in the way. Just wanting to see if you can cut out enough of the arm for clearance or mod the arm, or would it be a better option to mod the pump mounting bracket?

Can't comment. The car I'm referring to had a body mounted radiator.

I'd be careful about cutting the radiator support bracket.

Steve.

I recently put power steering in my zook i didnt have any trouble with pump clearance i also fitted a/c compressor at the same time but it is tight. I did have to move the radiator over about 40 mm to clear the p/s box though

jesse

Hey Jesse can u post a couple of photos?

I used stock vitara pump and converted all the pulleys to multi rib belt aswell. The bracket for the a/c and p/s pump bolted straight on and it came off a 1.6 carby motor the crank pulley had the be modified to fit the sierra 1.3 though.
this is all i have at the moment



This is how much clearance there is from everything.
Remember the engine tourqes the opposite way.

thanks for the pix, i'm running a trail tough pulley with the standard v belt on the water pump and alternator and the rib belt on the power steer. does the radiator have to be moved to fit the jimny box? if so how did u space it over ?

i didnt use the jimny box i used the vitara box so im not sure whether that will clear sorry

but when i spaced it over i cut a v out in to places and bent it back to shape and re drilled the driver side

jesse

Zookster, I'm pretty sure that's not the standard configuration though - the PS pump is down the bottom where your AC is AFAIK.

I set up Greg's taxidermist's car with the PS pump up high like yours and the endless air under it and it's been good. (It runs an AU falcon pump)

Steve.

My vit pump (on vit engine) is at the bottom and I did have to cut the radiator support to clear then I strenghted the front side to stop it flexing.
Nik

Oh ok i just unbolted it off the 1600 i have out the back so i assumed that it was standard sorry about that.

jesse

I started fitting up the box and pump today. the jimny box fits with no mods , and to make room for the vitara pump with vitara mounting bracket i'll have to cut off radiator support bracket from chassis , re weld further foward and straighten out support arm as steve and nik stated,too easy. Thanks all for help .