Page 1 of 1
tray suited for competition use?
Posted: Mon May 18, 2009 6:00 pm
by collins110
hey guys im looking into buying this tray:
but i want to know whether it would pass CAMS inspections and whether id need to put some more supports to the chassis from the roll bar...and any other modifications
Posted: Mon May 18, 2009 6:06 pm
by Weiner
http://www.ccda4wd.com.au/images/CCDAFW ... ion9.0.pdf
Nope.
Page 36
All tubing used in roll bar protection structures shall be circular section cold drawn steel tube (CDS, CDW or CEW) with properties shown in the following tables.
Posted: Mon May 18, 2009 6:18 pm
by blurredvision
Any questions with regards to Offroad racing CAMS rules, the rulebook can be downloaded from the site. Otherwise you can call Morrie Williams 0412 361 864 who is the tech inspector for offroad nationally. He will be able to sort out any questions. Good luck with your project.
Posted: Mon May 18, 2009 6:25 pm
by collins110
well would i be able to use this as a base and just cut the bar off and get another one made?
Posted: Mon May 18, 2009 6:34 pm
by Gwagensteve
CCDA/CAMS aren't going to care if you're only just bolting the cage through it - the cage will be the important/expensive bit.
Get stuck into the rulebook mate.
If you can/have to pay to get a proper cage built the tray is the simple bit.
Steve.
Posted: Mon May 18, 2009 7:09 pm
by Weiner
collins110 wrote:well would i be able to use this as a base and just cut the bar off and get another one made?
For sure, why not just make one yourself, one you like?
It isn't hard, you can make it to suit your car, as its an older model one yeah?