Outer Limits 4x4 Board

Posted: **Tue Jun 16, 2009 5:34 pm**

Hi All,

Can any of you fine chaps tell me what are the measurements between all the top holes on the exhaust manifold are? The reason I ask is that I am about to get a flange laser cut so I can start my turbo conversion but I don't want to pull off my manifold until the new one is finished.

Thanks heaps,

Jamie.

ps. I tried to get a gasket to measure off but can't find a 1 piece one they all seem to be 6 individual gaskets!

Posted: **Wed Jun 17, 2009 5:31 pm**

There is a dxf file in this thread. The TB45 and TD42 have the same manifold bolt pitch etc.

http://www.outerlimits4x4.com/viewtopic.php?t=86831

Posted: **Thu Jun 18, 2009 6:38 pm**

brilliant, thanks very much

Posted: **Fri Jun 19, 2009 8:09 pm**

IF YOU HAVE NO LUCK LET ME KNOW AND I WILL TRACE ONE OUT AND POST IT TO YOU. THEN GET YOUR PLATE CUT FROM THAT

Posted: **Sat Jun 20, 2009 1:43 am**

There is a DX file link for this on the last post of this thread: http://www.outerlimits4x4.com/ftopic70825-0-asc-30.php

Posted: **Sat Jun 20, 2009 5:49 pm**

thanks heaps for your repleys, that DXF will work perfect!!

Posted: **Mon Jun 29, 2009 1:14 am**

I actualy have a few laser cut manifold plates for the tb42 I made a few manifolds , if interested in a set of plates about $80 maybe cheaper than getting a single set cut.

Posted: **Mon Jun 29, 2009 6:14 pm**

Battletruckmat wrote:IF YOU HAVE NO LUCK LET ME KNOW AND I WILL TRACE ONE OUT AND POST IT TO YOU. THEN GET YOUR PLATE CUT FROM THAT

Was it you that makes manifolds?

Cheers

Outer Limits 4x4 Board

TD42 Manifold dimensions

TD42 Manifold dimensions

thanks

lasercut manifolds