crossmember
Posted: Wed Jul 01, 2009 6:55 am
gday weiner yeh its the front and the back, i machined ten 50mm holes
on either side of 75x50x4mm thick rhs this is on the rear yesterday arvo
and just going to gusset from each corner of the crossmemeber to the chassis
either way holes or no holes i think its just going to be the same strength wise
kodie
on either side of 75x50x4mm thick rhs this is on the rear yesterday arvo
and just going to gusset from each corner of the crossmemeber to the chassis
either way holes or no holes i think its just going to be the same strength wise
kodie