Outer Limits 4x4 Board

Guys,
Just about to do a 2 inch body lift on the shorty and would like to hear any do's and don't in regard to doing this. Have heard that some smaller diameter type blocks tend to flex too much and tear off mounts on body and chassis. Is this correct?

complete instructions www.gqpatrol.com under on the left Bazzles Body Lift How To

Dont forget the booze when doin bodylift.. It helps with the thinking

make sure you spray those rear captive nuts with wd 40 the day before ,because thare are a bitch to undo. shane....

GQ wrote:Dont forget the booze when doin bodylift.. It helps with the thinking

Yep a sixpack for all envolved should be enough. Then another slab for the barbie afterwards.

When we redid my bodymount rubbers the other day, it took us fuck all to do the lot - couple a hours if that. And that was spraying the bolts there and then. Rattle gun at DAMIGES place helps though

Use NEW high tensile bolts, and its worth your while to do bodymount rubbers too...

Rear bolts come out easy on the day after an application of "Heat"
Melts the Locktite used by factory. WD40 wont break seal.

Bazzle

I curesed alot when I did mine. Then due to the friction the bolts got hot enough that you couldn't hold them.

I just cut a neat 40x40 hole knocked the tabs that hold the nut in place and then just replaced with a new high tensile bolt made a s/s cover plate for the hole sealed it with sticky back rubber and screwed the s/s cover plate on sweet as

As Bazzle said, we heat the rears up and they come out in 2 seconds.